Removal Of The Fuel Filter - PEUGEOT SpeedFight 3 Workshop Manual

SERVICE OPERATIONS
Slightly lubricate the brake cam and pin.
- Install the brake linings.
- Install the spring (8).
- Install the brake control cable, the barrel and
the adjusting nut (4).
- Install the wheel.
Tightening torque: 120 Nm.
When re-installing, use a new nut.
- Measure the free travel of the rear brake
control lever.
- Ajust the lever free travel using the adjusting
nut.
C. Brake control free travel: 10 to 20 mm.
- Install the exhaust.
Use a new exhaust gasket.
• Exhaust to cylinder mounting nut:
Tightening torque: 15 Nm.
• Exhaust to casing mounting bolt:
Tightening torque: 30 Nm.

Removal of the fuel filter

- Remove the footboard. See: Procedure 7
page 24.
- Lift the fuel tank.
- Clamp the end of the fuel inlet pipe using a
clip ref. 755996.
- Disconnect the fuel supply hose (1).
- Remove the fuel filter (2).
When re-installing, respect the
direction of installation of the filter
shown by the arrow which indicates in
which direction the fuel flows.
38
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
6
4
C
1
2
3
5
755996