Save Installation Settings; Technical Service Message; Reset Timer Database; Factory Setup (Restore Factory Defaults) - 3M XT-1 Operating Instructions Manual

Save Installation Settings

Note:
This function is only available to installers.
Perform the following procedure to save the current configuration into
permanent memory over the existing installation settings.
Important Note:
By performing this procedure you will be erasing the existing saved installation settings, making
it impossible to revert to the settings that were saved after installation.
• Enter the configuration mode, see page 5.
Select 14 Installer Setup.
•
Change the value for Save Installation Settings to Yes.
•

Technical Service Message

Perform the following procedure to customize the Service Screen message.
• Enter the configuration mode, see page 5.
Select 14 Installer Setup.
•
Change the value for Use Custom Tech Service Message? to Yes or No .
•
If you chose Yes , enter the customer message.
•

Reset Timer Database

Perform the following procedure to Reset the Timer module database.
• Enter the configuration mode, see page 5.
Select 14 Installer Setup.
•
Change the value for RESET Timer Database to Yes .
•
Note:
Resetting the Timer module Database will clear ALL vehicle timing data.

Factory Setup (Restore Factory Defaults)

Perform the following procedure to restore all of the configuration settings to the factory default settings. This
procedure should be performed only if the current configuration and the saved installation settings are unusable.
Important Note:
By performing this procedure you will reset the system to the initial configuration, making it impossible to
revert to the settings that were saved after installation.
• Enter the configuration mode, see page 5.
Select 15 Factory Setup.
•
Change the value of Restore All Factory Settings to Yes.
•
3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
Configuration
November 2011 - Revision 1.8
Page 23 of 65