Order Taking Modes Setup - 3M XT-1 Operating Instructions Manual

In the event the Kitchen Noise Reduction feature has been disabled due to a headset with an
older version of software having signed on, use the base station's menu to identify and remove
the offending headset(s) before restarting the base station, in order to restore the feature.
1. Identify the serial number(s) of the headset or headsets that have a software version other than v5.11
•
•
2. Unregister the headset(s) identified above by performing the following steps
•
•
•
•
3. Rebooting the base station will now restore the Kitchen Noise Reduction feature.

Order Taking Modes Setup

Perform the following procedure to enable or disable some of the seven
different order taking modes from appearing on the Run Menu:
• Enter the base station configuration mode, see page 5.
Navigate to 09 O.T. Modes Setup.
•
Change the value for each of the following options to Yes or No:
•
Manual Listen/Push To Talk
•
Manual Listen/Manual Latching Talk
•
Auto Listen/Push To Talk
•
Auto Listen/Manual Latching Talk
•
Hands Free
•
Outside
•
Always On (Bypass Vehicle Detector)
•
(Press
Notes:
Order taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.
3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
Enter the base station configuration mode, see page 5.
Navigate to 08 Headset Setup > Currently Editing Headset.
3 4
• Press or if necessary to scroll through the headsets. The
software version appears below the headset ID number.
Enter the base station configuration mode, see page 5.
Select 04 Registration > 2 Remove Headsets.
Scroll to the number of the headset you want to un-register.
Press Enter.
5 6
or to scroll up and down the list)
Configuration
November 2011 - Revision 1.8
Page 19 of 65