Kenmore 29" Installation Instructions Manual page 16

13. Check door strike alignment
Remove door strike and door strike plug from dryer cabinet. Insert
the door strike into door strike plug hole and secure with screw. Insert
door strike plug into original door strike hole and secure with screw.
Remove and transfer hinge hole plugs
Close door and check that door strike aligns with door catch. If it is
needed, slide door catch left or right within slot to adjust alignment.
TROUBLESHOOTING
See the "Use and Care Guide" or visit our website and reference
Frequently Asked Questions to possibly avoid the cost of a service call.
Use a small, fiat-blade screwdriver to gently remove 4 hinge hole
plugs on left side of dryer cabinet. Transfer plugs into hinge holes on
opposite side of dryer cabinet.
Insert screws in hinge holes on dryer
cabinet
NOTE: Two people may be needed to reinstall door.
Insert screws into the bottom holes on left side of dryer cabinet.
Tighten screws halfway. Position door so large end of door hinge slot
is over screws. Slide door up so screws are in bottom of slots. Tighten
screws. Insert and tighten top screws in hinges.
16