Kenmore 29" Installation Instructions Manual page 11

Alternate installations for dose clearances
Venting systems come in many varieties. Select the type best for your
installation. Two close-clearance installations are shown. Refer to the
manufacturer's instructions.
Over-The-Top installation (also available with one offset elbow)
Periscope installation
NOTE: The following kits for close clearance alternate installations are
available for purchase.
Ven_ing Ki_s
For more information, call ]=800=469=4663, or visit us
at www.seors.com, in Canada, call
1-800-469-4663 or visit us at www.seors.co.
Port Number Descrlpffons
8171587RP 0-5" Metal vent periscope
4396037RP 0"-18" Metal vent periscope
4396011RP 18" - 29" Metal vent periscope
4396014 29" - 50" Metal vent periscope
4392892 In-Wall metal DuraVent
TM
Periscope
4396028 Sure Connect
TM
venting kit
(over-the-top installation)
4396009RP 5' Universal connect vent, flexible dryer venting
4396010RP 6' SecureConnect
TM
vent, flexible dryer venting
4396013RB Dryer vent installer's kit
4396033RP 5' flexible dryer venting with clamps
4396727RP 8' flexible dryer venting with clamps
4396004 Dryer offset elbow
4396005 Wall offset elbow
4396006RW DuraSafe
TM
close elbow
4396007RW Through-the-wall vent cap
4396008RP 4" steel dryer venting clamps - 2 pack
8212662 Flush mounting Iouvered vent hood 4"
Special provisions for mobffe home instaffations:
The exhaust vent must be securely fastened to a noncombustible portion
of the mobile home structure and must not terminate beneath the mobile
home. Terminate the exhaust vent outside.
Determine vent path:
[] Select route that will provide straightest and most direct
path outdoors.
[] Plan installation to use fewest number of elbows and turns.
[] When using elbows or making turns, allow as much room
as possible.
[] Bend vent gradually to avoid kinking.
[] Use as few 90 ° turns as possible.
Determine vent length and elbows needed for best drying
performance:
[] Use following Vent System Chart to determine type of vent material
and hood combinations acceptable to use.
NOTE: Do not use vent runs longer than those specified
in Vent System Chart. Exhaust systems longer than those specified
will:
[] Shorten life of dryer.
[] Reduce performance, resulting in longer drying times
and increased energy usage.
The Vent System Chart provides venting requirements that will help
achieve best drying performance.
(f Vent $, 'stem Chart
Number of
90 ° turns or
elbows
0
1
4
Type
of vent
Rigldmetol
Rigldmetol
Rigldmetol
Rigldmetol
Rigldmetol
Box/Iouvered Angled
hoods hoods
64 ft. (20 m) 58 ft. (17.7 m)
54 ft. (16.5 m) 48 ft. (14.6 m)
44 ft. (13.4 m) 38 ft. (11.6 m)
35 ft. (10.7 m) 29 ft. (8.8 m)
27 ft. (8.2 m) 21 ft. (6.4 m)
NOTE: Side and bottom exhaust installations have a 90 ° turn inside
the dryer. To determine maximum exhaust length, add one 90 ° turn
to the chart.
11