Kenmore 29" Installation Instructions Manual page 13

2. Plan pipe fitting connection
g ¸
A. 3/8" flexible gas connector
B. 3/8" dryer pipe
C
Co 3/8" to 3/8" pipe elbow
D. 3/8" pipe-to-flare adapter fitting
A combination of pipe fittings must be used to connect dryer
to existing gas line. A recommended connection is shown. Your
connection may be different, according to supply line type, size,
and location.
3. Open shut=off valve
Closed valve
Open valve
Open shut-off valve in supply line; valve is open when handle is
parallel to gas pipe. Then, test all connections by brushing on an
approved noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leaks found.
CONNECT VENT
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer, if connecting to existing vent, make sure vent is clean. Dryer
vent must fit over dryer exhaust outlet and exhaust hood. Check that
vent is secured to exhaust hood with a 4" (102 mm) clamp.
Move dryer to final location. Avoid crushing or kinking vent. After
dryer is in place, remove cardboard from under the dryer.
LEVEL DRYER
1. keveJ dryer
Place level here Place level here
Check levelness of dryer from side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing system to
operate correctly.
Not Level LEVEL Not Level
2. Adjust leveling legs
if dryer is not level or the same height as the washer, prop up using a
wood block. Use wrench to adjust legs up or down, and check again
for levelness. Once legs are level, make sure all four legs are snug
against the floor before tightening them.
13