Kenmore 29" Installation Instructions Manual page 15

4. Remove screws from hinges
\
7. Rotate outer door
Rotate outer door 180 ° and set it back down on inner door. Reattach
outer door panel to inner door panel so handle is on the side where
hinges were just removed. Insert 4 door screws.
Remove screws attaching hinges to door.
5. Remove screws from door
Remove screws at top, bottom, and side of door (4 screws) that hold
the inner and outer door together. Holding door over towel on dryer,
grasp sides of outer door and lift to separate it from inner door. Set
outer door aside.
NOTE: Do not pry apart with putty knife or screwdriver. Do not pull
on door seal or plastic door catches.
F
6. Switch door catch, bezel, & plug
f
Catch and bezel Plug
Remove the door catch, bezel, and plug from the inside of the inner
door by squeezing and pulling/pushing them. Place the door catch,
bezel, and plug on the sides opposite from where they were.
8. Rip door over
Flip door over so handle side is down.
f
9. Attach door hinges
Reattach door hinges to dryer door so that the larger hole is at the
bottom of the hinge.
15