Kenmore 29" Installation Instructions Manual page 12

install exhaust hood and use caulking compound to seal exterior
wall opening around exhaust hood.
2. Connect vent to exhaust hood
Vent must fit inside the exhaust hood. Secure vent to exhaust hood
with 4" (102 ram) clamp. Run vent to dryer location using straightest
path possible. Avoid 90 ° turns. Use clamps to seal all joints. Do not
use duct tape, screws, or other fastening devices that extend into
interior of vent to secure vent, because they can catch lint.
INSTALL LEVELING LEGS
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
Prepare dryer for leveling legs
Screw in leveling legs
Using a wrench and tape measure, screw legs into leg holes until
bottom of foot is approximately 1/2" (13 mm) (to match height of
3.6 cu. ft. capacity washer) or 11/2'' (38 mm) (to match height of
3.8 cu. ft. capacity washer) from bottom of dryer.
Now stand the dryer on its legs. Slide the dryer until it is close to its
final location. Leave enough room for electrical connection and to
connect the exhaust vent.
For mobffe home use
Gas dryers must be securely fastened to the floor.
Mobile home installations require a Mobile Home installation Hold-
down Kit. For ordering information please sse your "Use and Care
Guide".
MAKE GAS CONNECTION
• Connect gas supply to dryer
Flared
male fitting
Non-flared
male fitting
Remove red cap from gas pipe. Using a wrench to tighten, connect
gas supply to dryer. Use pipe-joint compound on threads of all non-
flared male fittings. If flexible metal tubing is used, be sure there are
no kinks.
NOTE: For LP gas connections, you must use pipe-joint compound
resistant to action of LP gas. Do not use TEFLON @ tape.
To avoid damaging floor, use a large flat piece of cardboard from
dryer carton; place under entire back edge of dryer. Firmly grasp
dryer body (not console panel) and gently lay dryer down on
cardboard.
t®TEFLON is a registered trademark of E.I. Dupont De Nemours and Company.
12