Replacing The Rewind Spring (036, 036 Qs); Spring (034) - Stihl 034 Series User Manual

7.3 Rewind Spring
7.3.1 Replacing the Rewind Spring (034)
– Remove the rope rotor -
Use suitable pliers to grip the
anchor loop of the rewind spring
and lift it up.
– Take the spring housing and
rewind spring out of the fan
housing.
– Remove any remaining bits of
spring from the fan housing.
– Lubricate die rewind spring with
STIHL special lubricant and fit it
with the spring housing (bottom
plate facing up) in the fan
housing.
– Engage the spring loop over the
lug in the fan housing.
Warning:
The rewind spring may pop out and
uncoil during installation. If the
rewind spring has popped out, refit it
in the spring housing as follows:
034, 036, 036 QS
Position anchor loop about
see 7.2.
25 mm from the edge of the
spring housing.
Refit the rewind spring in the
spring housing in the counter-
clockwise direction, starting
outside and working inwards.
– Fit the spring housing in the fan
housing.
– Engage the spring loop over the
lug in the fan housing.
– Install the rope rotor -
– Tension the rewind spring -
7.4.
7.3.2 Replacing the
Rewind Spring
(036, 036 QS)
– Remove the rope rotor -
– Use suitable pliers to grip the
anchor loop of the rewind spring
and pull it out carefully.
Warning:
The rewind spring jumps out of its
seat in the fan housing in this
process.
– Remove any remaining bits of
spring from the fan housing.
– Lubricate the rewind spring with
STIHL special lubricant.
Engage the anchor loop over the
lug in the fan housing and fit the
rewind spring in the fan housing
in the clockwise direction, starting
outside and working inwards.
– Install the rope rotor -
– Tension the rewind spring -
7.4.
see 7.2.
see
see 7.2.
see 7.2.
see
41