– Unscrew the hexagon nuts.
Unscrew the spindle clockwise
and take away the service tool.
– Take out the two M5x72 screws.
Drive home the two dowel pins.
Fit the five crankcase mounting
screws and tighten them down
alternately in a diagonal pattern
(see "Tightening Torques").
30
Trim away any excess gasket
material in the area of the
cylinder mounting face.
If the crankshaft does not turn
freely, it is sufficient to tap the
end of the stub with a plastic
mallet to relieve axial stresses.
Before installing oil seal, coat
cavity between dust and sealing
lips with grease -
see
Fit the installing sleeve (1)
1118 893 4602 over the clutch
end of the crankshaft.
Slip the oil seal (2), open side
facing the crankcase, over the
installing sleeve.
1
Press home the oil seal with
press sleeve (1) 1118 893 2401.
13.2.
– Remove the installing sleeve.
1
2
034, 036, 036 QS