Stihl 034 Series User Manual page 13

1
Carefully pry the brake spring (1)
off the anchor pin and disconnect
it from the lever (2).
2
1
Remove the screw (1).
Ease the brake band (2) out of
its seat in the crankcase and
disconnect it from the lever (3).
Remove screw with captive
washer from the hand guard.
Note:
When installing, tighten down the
screw with captive washer firmly
(see "Tightening Torques").
034, 036, 036 QS
2
Carefully pry spring (1) off the
pivot pin.
3
2
Pull the hand guard (2) and brake
lever (1) off the pivot pins.
Disconnect brake cable (1) from
the brake lever (2).
– Take the brake lever out of the
hand guard.
1
Disconnect spring (1) from
lever (2).
Pry the E-clip (3) off the pivot pin
and remove the lever with spring.
Clean all disassembled parts in
white spirit. Replace any worn or
damaged parts.
1
2
1
1
2
3
13