Tank Housing; 12.8.1 Removing And Installing - Stihl 034 Series User Manual

12.8

Tank Housing

12.8.1 Removing and Installing

– Drain the tank housing.
Remove mounting screws from
side of front handle.
Remove mounting screws from
underside of front handle. Lift
away the handle.
Note:
To remove front handle on
machines with handle heating
see 10.4.
– Remove the carburetor -
see 12.3.
– Remove the shroud - see
034, 036, 036 QS
Pull the washer (1) off the studs
and remove the sleeve (2) from
the manifold.
Pull the connector sleeves of the
short circuit wire (2) and ground
wire (1) off the contact springs.
4.3.
– Remove the fan housing -
6.4.1.
Pry the plug (1) out of the annular
buffer at the ignition side.
1
2
Remove the annular buffer
– Remove the chain catcher -
1
2
Pry the plugs out of the annular
– Remove annular buffer mounting
1
Pull the grommet with ground and
see
mounting screw.
see 4.2.
buffers at the starter side.
screws.
short circuit wires out of the
crankcase.
69