Page 1
PMMC3 (Picco de 3/8 pulg) o PMC3 (Picco de 3/8 pulg) de STIHL, dependiendo de la rueda dentada usada y de otros componentes reductores de contragolpe. Read and follow all safety precautions in Instruction Manual –...
Page 3
Operating Instructions can go to www.stihlusa.com. Taking Care of the Guide Bar Air Filter System Contact your STIHL dealer or the STIHL distributor for your area if you do not Cleaning the Air Filter understand any of the instructions in this Engine Management manual.
Page 4
Engineering Improvements Fuel tank; fuel mixture of Symbols in Text gasoline and engine oil STIHL’s philosophy is to continually improve all of its products. As a result, Many operating and safety instructions Chain oil tank; chain oil engineering changes and improvements are supported by illustrations.
Page 5
Most of these safety precautions and trained in special serious or fatal injury. warnings apply to the use of all STIHL cutting and work- chain saws. Different models may have ing techniques and different parts and controls. See the...
Page 6
Warning! disease. In order to reduce the risk of The ignition system of the STIHL unit Physical Condition whitefinger disease and carpal tunnel produces an electromagnetic field of a...
Page 7
Use proper equipment at all times to protect your- Fuel self from falling. Your STIHL power tool uses an oil- gasoline mixture for fuel (see chapter on "Fuel" of your instruction manual). MS 192 T, MS 192 TC...
Page 8
Never remove the fuel To do this with this STIHL cap, raise the filler cap while the engine is running. grip on the top of the cap until it is upright at a 90°...
Page 9
Chain" of your instruction manual. STIHL dealer for repair. grease or resin in order for you to STIHL Oilomatic chain, guide bar and maintain a firm grip and properly control sprocket must match each other in See also the "Fueling" chapter in your your power tool.
Page 10
If you cannot set the correct idle speed, (see section on reactive forces). To have your STIHL dealer check your reduce this risk, always engage the power tool and make proper chain brake before starting. Never adjustments and repairs.
Page 11
English and kickback forces of your saw without losing control (see section on reactive Warning! forces). Keep proper footing and balance at all To reduce the risk of seri- times. Special care must be taken in ous or fatal injury to the slippery conditions (wet ground, snow) operator or bystanders and in difficult, overgrown terrain.
Page 12
English it to the lifeline. Cordon off the work area Working Conditions in order to reduce the risk of injuries and Warning! Operate and start your power tool only damage to bystanders or property (e. g. outdoors in a well-ventilated area. As soon as the engine is motor vehicles) from falling branches.
Page 13
English Warning! Warning! Warning! Inhalation of certain dusts, especially Breathing asbestos dust is dangerous Never touch a chain with your hand or organic dusts such as mold or pollen, and can cause severe or fatal illness, any part of your body when the engine can cause susceptible persons to have respiratory illness or cancer.
Page 14
Antivibration elements should always hearing loss. You may also permanently muffler maintained by a STIHL servicing be replaced in sets. If you have any damage the engine. Have your muffler dealer. Some state or federal laws or...
Page 15
Reactive forces may occur any time the and force of the kickback reaction. Some chain is rotating. Reactive forces can STIHL bar and chain types are designed cause serious personal injury. to reduce kickback forces. STIHL recommends the use of reduced kickback bars and low kickback chains.
Page 16
The computer-derived angles for saws See the section on "Low kickback saw All STIHL chain saws are equipped with below 3.8 cubic inches (62 cm³) chain and reduced kickback bars". a Quickstop chain brake which can be displacement are measured by applying activated by inertia.
Page 17
Kickback Bars back chains do not prevent kickback, Warning! but they are designed to reduce the risk STIHL offers a variety of bars and An improperly maintained chain brake of kickback injury. They are available chains. STIHL reduced kickback bars may increase the time needed to stop from your STIHL dealer.
Page 18
Do not mount a bow guide on any been specifically certified to comply with with a correctly sharpened, properly STIHL chain saw. Any chain saw the 45° computer derived kickback tensioned chain at all times. equipped with a bow guide is potentially angle of §...
Page 19
STIHL Chain Saw Safety may cause loss of saw control. Manual, which is available free from Pushback frequently occurs when the your STIHL servicing dealer.
Page 20
Have such work per- fied. An improperly maintained muffler operator and cause loss of control of the formed by your STIHL servicing dealer will increase the risk of fire and hearing saw and severe or fatal injury to the only.
Need help?
Do you have a question about the STIHL MS 192 T and is the answer not in the manual?
Questions and answers