Lucent Technologies Host-Based Controller Modem AT Data Addendum page 27

Data Addendum
June 15, 1998
Test and Debug AT Commands (continued)
Table 7 - errorControl Active from 3.5.2/V.58
Value Description
0 Disable/none
1 V.42 LAPM
2 V.42 Alternative protocol (MNP™)
3-7F Reserved (V.58)
80 MNP10™
81 ECP™ Enhanced Cellular Protocol
82 ETC
82-FF Reserved for mfgs
Table 8 - compressionActive from 3.2.2/V.58
Value Description
0 None
1 V.42bis
2-7F Reserved (V.58)
80 MNP5™
81-FF Reserved for mfgs
Table 9 - Additional callCleared codes (3.6.4/V.58)
Code Definition
1 No Previous call
2 Call is still in progress
3 Call Waiting signal detected
4 Delayed - see ETS 300 001
Table 10 - callCleared codes from 3.6.4/V.58-1994
callCleared: Indicates that the DCE has gone on hook and that the previously existing network connection has
been cleared. These values are hexadecimal, converted from decimal in V.58.
Value Description
0 CauseUnidentified
1-3 See Table 9 above
A NMSinitiatedDialCall
B NMSinitiatedLeasedLineRestoral
C NMSinitiatedRedial
D NMSinitiatedDialDisconnect
14 PowerLoss
15 EquipmentFailure
16 FrontPanelDisconnectRequested
17 FrontPanelLeasedLineRestoral
18 AutomaticLeasedLineRestoral
19 InactivityTimerExpired
1E cct116RestoralRequest
1F cct108isOffInhibitsDial
20 cct108turnedOff
28 NoNumberProvided
29 BlacklistedNumber
Version 1.0
Implemented
Implemented
Implemented
Notes
Call setup issues
-- Network Management System
DCE
DTE Interface
Line Interface
Lucent Technologies Inc.
Host-Based Controller Modem
X
X
X
X
X
X
X
X
X
AT Command Set
Implemented
X
X
X
X
27