Lucent Technologies Host-Based Controller Modem AT Data Addendum page 11

Data Addendum
June 15, 1998
AT Command Reference (continued)
On Return On-line to Data Mode
O0:
O1:
O3:
Result Codes:
OK
ERROR
P Select Pulse Dialing
This command configures the modem for pulse (non touch-tone) dialing. Dialed digits are pulsed until a T
command or dial modifier is received. Tone dial is the default setting.
Qn Result Code Control
Result codes are informational messages sent from the modem and displayed on your monitor. Basic result
codes are OK, CONNECT, RING, NO CARRIER, and ERROR. The ATQ command allows the user to turn result
codes on or off.
Q0:
Q1:
Result Codes:
OK
ERROR
T Select Tone Dialing
This command instructs the modem to send DTMF tones while dialing. Dialed digits are tone dialed until a P
command or dial modifier is received. This is the default setting.
Vn DCE Response Format
This command controls whether result codes (including call progress and negotiation progress messages) are
displayed as words or their numeric equivalents. For the result code, see table 4.
V0:
V1:
Result Codes:
OK
ERROR
ATV0
Result Code Format <numeric code> <CR>
Version 1.0
Instructs the modem to exit on-line command mode and return to data mode
(see AT Escape Sequence, +++).
This command issues a retrain before returning to on-line data mode.
This command issues a rate renegotiation before returning to on-line data mode.
n = 0, 1, 3
Otherwise
Enables modem to send result codes to the computer (default).
Disables modem from sending result codes to the computer.
n = 0, 1
Otherwise
Displays result codes as digits.
Displays result codes as text (default).
n = 0, 1
Otherwise
Lucent Technologies Inc.
Host-Based Controller Modem
ATV1
<CR> <LF>
<verbose code> <CR> <LF>
AT Command Set
11