Table of Contents
Advertisement
Host-Based Controller Modem
AT Command Set
AT Command Reference (continued)
\N3:
V.42, MNP, or buffer (default).
The modem attempts to connect in V.42 error control mode. If this fails, the modem attempts to
operation. This
\N4:
V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If this fails, the
call
\N5:
V.42. MNP or buffer (same as \N3).
\N7:
V.42. MNP or buffer (same as \N3).
Result Codes:
OK
ERROR
Otherwise
\Q
Local Flow Control Selection
\Q0:
Disable flow control. Same as &K0.
\Q1:
XON/XOFF software flow control. Same as &K4.
\Q2:
CTS-only flow control. This is not supported and the response is ERROR.
\Q3:
RTS/CTS to DTE (default). Same as &K3.
Result Codes:
OK
ERROR
\Rn
Ring indicator signal off after the telephone call is answered (Compatibility command)
\R0:
Result Codes:
OK
ERROR
Otherwise
20
connect in MNP mode. If this fails, the modem connects in buffer mode and continues
is also known as V.42/MNP auto reliable mode (same as &Q5).
will be disconnected.
n = 0, 1, 2, 3, 4,5,7
n = 0, 1, 3
Otherwise
ring indicator signal is off after the telephone call is answered
n = 0
Lucent Technologies Inc.
Data Addendum
June 15, 1998
Version 1.0
Advertisement
Table of Contents
Need help?
Do you have a question about the Host-Based Controller Modem AT and is the answer not in the manual?