Fujitsu MAA3182SC Oem Manual page 212

Name
C* Q*
2A 01 Mode parameter
changed
2A 02 Log parameter changed The LOG parameter value was changed by another INIT.
2C 00 Command sequence
error
2F 00 Command cleared by
another INIT
31 00 Medium format
corrupted
31 01 FORMAT command
failed
32 00 No defect spare
location available
32 01 Defect list update failure Updating of the defect list (G List) failed.
37 00 Rounded parameter
3D 00 Invalid bits in
IDENTIFY message
3E 00 Logical unit has not
self-configured yet
3F 00 Target operating
conditions have changed
40 nn Diagnostic failure on
component "nn"
43 00 Message error
* C: Sense Code, Q: Sub-sense Code
Table 4.2 Sense and subsense codes (4 of 7)
The MODE SELECT parameter values were changed
by another INIT.
The SET LIMITS command was issued 2 times in a
group of commands linked in a series.
There is an operation which cannot be executed without
being linked to the INITIATE SA OP command.
A command was forcibly terminated by another INIT
during execution or queuing.
• By a CLEAR QUEUE message
• The sense hold state was entered when the QErr bit
was set on "1."
• The DQue bit was changed from "0" to "1."
The media format is different from the original format.
(The media was not formatted after the data format
specification was changed by the MODE SELECT
command.)
For some reason, formatting cannot be completed and
reformatting is necessary.
No usable alternate block area exists. Or alternate block
processing cannot be performed due to control table
overflow.
Rounding processing of the MODE SELECT parameter
specified by the command was performed.
"1" was specified in the reserve bit of the IDENTIFY
message.
The IDD's initial setup operation is not completed.
Operating conditions were changed by another INIT.
An error was detected in self-diagnosis. ("nn" is a
Fujitsu unique code (80 to FF))
• 80: RAM DATA compare error
• 81: RAM parity error
• 82: TEC register error
• 83: Drive interface register error
• 84: Firmware check sum error
• 90: DSP does not respond
• 91: DSP self-diagnosis error
A message sent by the IDD was illegally rejected.
C141-E039-01EN
Explanation Sense
key
6
6
7
5
6
3
3
4
4
1
5
2
6
4
B
4 - 9