Fujitsu MAA3182SC Oem Manual page 191

Note:
The value of the "Page Parameter Length" field in this response data is a variable length
within the range of [2 + 8n] in the SCSI specifications. For example, If multiple logical
data blocks are located in 1 physical sector, or if 1 logical data block is located in multiple
physical sectors, n address information items are reported as the address conversion
results.
In the current IDD specifications, multiple address information items are not reported in
this response data, but the "Page parameter length" always shows X '000A.' However,
considering expanded specifications in the future, the INIT should make it possible to
correspond to variable lengths for the "Page parameter length."
The "Address Format Before Conversion" field in byte 4 and the "Address Format After
Conversion" field in byte 5 are the same values as the codes which show the expression format
for address information specified by the SEND DIAGNOSTIC command parameters. The
"Address Format After Conversion" field shows the expression format of the address
information reported in bytes 6 to 13 of this response data. "Address format" codes are as
shown below.
Code
0 0 0
1 0 0
1 0 1
The description of address information shown in bytes 6 to 13 is the same as the description
specifications in the D List transferred from the INIT by the FORMAT UNIT command. For
details, see the description of the FORMAT UNIT command (item 3.3.1). Furthermore, When
the logical block format is used, the address is shown in bytes 6 to 9 and zero is reported in the
remaining byte positions. However, when the address information specified in the "SEND
DIAGNOSTIC command points to a position on the disk media which is not used as physical
data blocks, X 'FFFFFFFF 00000000' is reported as the logical block address after
conversion.
3 - 122
Logical Block Address Format
Byte Distance from the Index Format
Physical Sector Address Format
C141-E039-01EN
Address Format