Table of Contents
Advertisement
C*
Q*
Name
1C
00 Defect list not found
01 Primary defect list not
found
02 Grown defect list not
found
03 SA control list not
found
04 Defect table list not
found
05 Cylinder skew list not
found
00 Miscompare during
1D
verify operation
80 Miscompare during
self diagnostic
operation
00 Invalid command
20
operation code
00 Logical block address
21
out of range
00 Invalid field in CDB
24
00 Logical unit not
25
supported
00 Invalid field in
26
parameter list
00 Write protected
27
01 Power on occurred
29
02 SCSI reset occurred
03 BUS DEVICE RESET
message occurred
* C: Sense Code, Q: Sub-sense Code
4 - 8
Table 4.2
Sense and subsense codes (3 of 7)
The defect management information header is incorrect.
The defect list (P List) header is incorrect.
The defect list (G List) header is incorrect.
The SA update control code header is incorrect.
The defect management table header is incorrect.
The cylinder skew table header is incorrect.
Comparison of data transferred from the INIT by a
VERIFY command (when the Byte Check mode was
specified) with data read from the disk media was
terminated unsuccessfully.
Data written to the disk media failed to match data read
from the disk media during self-diagnosis (read/write
test).
CDB byte 0 (operation code) is illegal.
A logical block address which exceeds the drive's
maximum value was specified.
There is an error in a specification in the CDB.
An illegal LUN was specified.
There is an error in the parameter list specifications
transferred from the INIT during command execution.
A write operation was attempted in a write protected
area. Or a write operation is prohibited at the external
operation panel.
Microcode was downloaded immediately after power
on.
A SCSI RESET was received.
A BUS DEVICE RESET message was received.
C141-E039-01EN
Explanation
Sense
key
3
3
3
3
3
3
E
E
5
5
5
5
5
7
6
6
6
Advertisement
Table of Contents
