Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X10DRT-H User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
LE1
VGA COM1
JB1 A
1 C
UID JVGA JCOM1
JUIDB1
1 JIB1
LAN2 LAN1
3
C
QSFP
LEDBMC
1
JSTBY1
1
JB3
1 JPB1:BMC
1-2:ENABLE
2-3:DISABLE
JB2
3
JP1
1
JP2
BT1
JBT1:
CMOS
CLEAR
MH1
CPU1
CLOSE 1st
OPEN 1st
CPU2
CLOSE 1st
OPEN 1st
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.
modules to prevent any possible damage.
JUSBRJ45
1 1
JSD2
+
CAUTION
Release Tabs
2-11
Chapter 2: Installation
Notches