Supermicro X10DRT-H User Manual page 13

Jumper
JVRM1/JVRM2
JBT1
JPB1
JPG1
JPL1
JI2C1/JI2C2
JIB1
JWD1
JPME2
X10DRT-H/HIBF Motherboard Connectors
Connectors
Battery
COM1
FAN3
JF1
JIPMB1
JSD1/JSD2
JTPM1
JSTBY1
LAN1/2
(IPMI) LAN
QSFP
I-SATA0~1
Slot1
SXB2
SXB1
UID SW
USB0/1 (3.0)
VGA
S-SATA0/1
X10DRT-H/HIBF Motherboard Jumpers
Description
I C Bus for VRM
2
Clear CMOS/Reset BIOS Configura-
tion
BMC Enabled
VGA Enabled
LAN Enable
SMB to PCI Slots
Infiniband (IB) Enable/Disable
Watch Dog
Manufacturing Mode
Description
Onboard Battery (See the Note on P. 1-3.)
Serial Port/COM Port 1
System Cooling Fan Header
SMC Proprietary Slot for SMC Add-On Card for Power,
Front Control Panel
4-pin External BMC I
SATA DOM (Device_On_Module) Power Connector
TPM (Trusted Platform Module)/Port 80
Wake-On-LAN Header
G-bit Ethernet Ports 1/2
IPMI_Dedicated LAN
Quad (4-channel) Small Form-factor Pluggable (QSFP)
Connector used as Connect-X3 FDR 56GT/s InfiniBand
Port (for X10DRT-HIBF)
SATA3 Drive Connectors
PCI-E 3.0 x16 Slot supported by CPU1
PCI-E 3.0 x8 (in x4) Slot supported by CPU2
PCI-E 3.0 x8 (in x4) Slot supported by CPU1
UID (Unit Identifier) Switch
Back Panel USB 3.0 Ports 0/1
Backpanel VGA Port
SATA DOM Connector
C Header (for an IPMI Card)
2
1-5
Chapter 1: Overview
Default Setting
Pins 1-2 (BMC:
Normal)
See Chapter 2
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (RST)
Pins 1-2 (Disabled)