Diskonchip 2000 Quick Installation Guide; Diskonchip 2000 Installation Instructions - Advantech PCA-6166 User Manual

C.1 DiskOnChip
Guide
C.1.1 DiskOnChip
1. Make sure the target platform is powered OFF.
2. Plug the DiskOnChip
direction is correct (pin 1 of the DiskOnChip 2000 is aligned with
pin 1 of the socket).
3. Power up the system.
4. During power up you may observe the messages displayed by the
DiskOnChip 2000 when its drivers are automatically loaded into
the system's memory.
5. At this stage, the DiskOnChip 2000 can be accessed as any disk in
the system.
6. If the DiskOnChip 2000 is the only disk in the system, it will
appear as the first disk (drive C: in DOS).
7. If there are more disks besides the DiskOnChip 2000, the DiskOn-
Chip 2000 will appear by default as the last drive, unless it was
programmed as the first drive. (Please refer to the DiskOnChip
2000 utilities user manual.)
8. If you want the DiskOnChip 2000 to be bootable:
a. Copy the operating system files to the DiskOnChip by using the
standard DOS command (for example, SYS d:).
b.The DiskOnChip should be the only disk in the systems or
would be configured as the first disk in the system (c:) using the
DUPDATE utility.
DUPDATE C /S: DOC104.EXB /FIRST
DUPDATE D /S: DOC104.EXB
118 PCA-6166 User's Manual
®
2000 Quick Installation
®
2000 installation instructions
®
2000 device into its socket. Verify the
(set as c:)
(set as d:)