Setup; Ac Power; Fuse Replacement; Fuse Replacement Diagram - Chauvet SlimPAR HEX 6 IRC User Manual

3. S
ETUP

AC Power

Fuse
Replacement

Fuse Replacement

Diagram
SlimPAR™ HEX 6 IRC User Manual Rev. 3
The SlimPAR™ HEX 6 IRC has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the
current value listed on the label affixed to the product's back panel, or refer to the
Technical Specifications
current draw under normal conditions.
For more information, you may download Sizing Circuit Breakers from the Chauvet website:
www.chauvetlighting.com/download/.
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure the
product has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel is configured as a 0 to 100% switch.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and rating.
6. Insert the fuse holder back in place and reconnect power.
Disconnect the product from power before replacing the fuse.
Spare Fuse Holder
(inside safety cap)
Always replace a blown fuse with another of the same type and rating.
A spare fuse is not included; however, the safety cap has room for a spare.
in this manual. The listed current rating indicates the product's average
Installed Fuse
(held by plastic clip)
Safety cap
Page 8 of 24