Product At A Glance; Safety Notes - Chauvet SlimPAR HEX 6 IRC User Manual

Product at a
Glance

Safety Notes

Page 5 of 24
Use on Dimmer
Outdoor Use
Sound-Activated
DMX
Master/Slave
These notes include important information about the mounting, use, and maintenance of this
product. Read these notes before using the product.
· Always connect the product to a grounded circuit to avoid the risk of electrocution.
· Make sure the power cord is not crimped or damaged.
· Always disconnect the product from the power source before cleaning it or replacing the fuse.
· Never disconnect the product from the power source by pulling or tugging on the cord.
· If mounting the product overhead, always secure it with a safety cable.
· Make sure there are no flammable materials close to the product when it is operating.
· Avoid direct eye exposure to the light source while the product is on.
· Do not touch the product's housing when the product is operating.
· This product is not intended for permanent installation.
· The product is for indoor use only.
· Do not expose the product to rain or moisture.
· Make sure that the voltage of the power source used for the product is within the range stated on
the label, on the rear panel of the product, or
· Never connect the product to a dimmer or a rheostat.
· Make sure to replace the fuse with another fuse of the same type and rating.
· Always install the product in a location with adequate ventilation, and leave at least 20 in (50 cm)
between the product and adjacent surfaces.
· Be sure that no ventilation slots on the product's housing are blocked.
· Do not operate the product in an ambient temperature higher than 104 °F (40 °C).
· Always carry the product by the mounting bracket.
· In the event of a serious operating problem, stop using the product immediately.
· Never try to repair the product. Repairs carried out by untrained people can lead to damage or
malfunction.
· If repairs are required, contact the nearest authorized technical assistance center.
See Contact Us at the end of this manual.
· To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via the breaker or by unplugging it.
Keep this User Manual for future reference. If you sell the product to another user, be sure to give
this manual to the next owner.
x
Auto Program
x
Auto-Ranging Power Supply
P
Replaceable Fuse
P
User-Serviceable
P
Technical Specifications
SlimPAR™ HEX 6 IRC User Manual Rev. 3
P
P
P
x
in this manual.