Table of Contents
Advertisement
Chapter 6: Advanced Chassis Setup
SCA Backplane
The SCSI drives plug into a SAF-TE compliant SCA backplane that provides
power, SCSI ID and bus termination. A RAID controller can be used with
the SCA backplane to provide data security. The operating system you use
must have RAID support to enable the hot-swap capability of the SCSI
drive.
The SCA SCSI backplane is already preconfigured; there are no
jumpers or switches.
Figure 6-5.
SCSI SCA Backplane
SCSI ID#0
SCSI ID#3
SCSI ID#4
SCSI ID#1
SCSI ID#5
SCSI ID#2
SCSI ID#6 is used for the SAF-TE Controller
Installing a Component in the 5 1/4" Drive Bay
1.
Mounting the component in the drive carrier
A component such as an IDE hard drive or an additional SCSI drive that
can fit into a standard IDE drive bay can be mounted in the 5 1/4" drive
bay. The component should also be mounted in a drive carrier to simplify
its installation and removal from the chassis. These carriers also help
promote proper airflow.
For this reason, even empty carriers without a
component installed must remain in the chassis. To add a component
such as those noted above, install a drive into the carrier with the printed
circuit board side toward the carrier so that the mounting holes align with
those in the carrier. Secure the drive to the carrier with the four
s c r e w s .
6-7
Advertisement
Table of Contents
