Table of Contents
Advertisement
A
BUZZER RESET
FAN#3
D
JP43
Location
A
B
C
D
*Pressing the mute button on the control panel will disable the buzzer alarm.
You should then press the button once again to re-enable the alarm.
Installing a Component in the 5.25" Drive Bay
1.
Mounting the component in the drive carrier
A component such as an IDE hard drive or an additional SCSI drive that
can fit into a standard IDE drive bay can be mounted in the 5.25" drive bays.
The component should also be mounted in a drive carrier to simplify its
installation and removal from the chassis. These carriers also help promote
proper airflow. For this reason, even empty carriers without a component
installed must remain in the chassis. To add a component such as those
noted above, install a drive into the carrier with the printed circuit board side
toward the carrier so that the mounting holes align with those in the carrier.
Secure the drive to the carrier with the four screws.
Figure 6-5.
SCSI SCA Backplane
SCSI Backplane Jumper Settings
Jumper Description
JP19
Buzzer Reset*
JP41
FAN#1 On/Sense
JP42
FAN#2 On/Sense
JP43
FAN#3 On/Sense
Chapter 6: Advanced Chassis Setup
FAN#2
FAN#1
C
B
JP42
JP41
Default Setting
Open
Open
Open
Open
6-7
S
UPER
SCA833S
Advertisement
Table of Contents
