Table of Contents
Advertisement
Installing a Component in the 5.25" Drive Bay
A single 5.25" drive bay is located in the front of the chassis, making it easily acces-
sible for installation and removal. This component is not hot-swappable, meaning
system power must be turned off before installing and/or removing them.
Installing/Removing a 5.25" Drive Bay Component
1.
First power down the system and then remove the top cover of the chassis.
2.
Push the locking latch to the right, then remove the drive carrier from the
chassis.
3.
Attach the component to the carrier if installing.
4.
Push the tray with the drive back into its bay in the chassis.
5.
Replace the top cover and restore power to the system when fi nished.
Chapter 6: Advanced Chassis Setup
6-7
Advertisement
Table of Contents
