Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Hunter Stoves Manuals
  4. Stove
  5. Hawk
  6. Installation and servicing instructions

Hunter Stoves Hawk Installation And Servicing Instructions

Hide thumbs Also See for Hawk:

Advertisement

Quick Links

Download this manual See also: Instructions for Installation and Servicing, Instructions for Using
!
"
# "
#
#
#
# "

Advertisement

loading
Need help?

Need help?

Do you have a question about the Hawk and is the answer not in the manual?

Questions and answers

Related Manuals for Hunter Stoves Hawk

Summary of Contents for Hunter Stoves Hawk

  • Page 1 " # " # "...
  • Page 2 ....................3 TOVE IMENSIONS ..................4 INSTALLATION NOTES ....................6 RRANGEMENT (GB O ) ..............6 DDITIONAL ENTING ..................7 PENING THE TOVE ..................7 UPPLY ONNECTIONS ..................8 ESTING UPPLY RESSURE ! "# FIRE-BED ARRANGEMENT ..............9 ................9 ITTING THE ERAMIC ATRIX Section A - Fitting the Loose Ceramic Coals.............10 Section B - Fitting the Loose Ceramic Logs ............11 –...
  • Page 3 &! /0,# 1 ,# + - 2 + - 2 4 %/2/%0 5 /2' 0 %9 : /9 : /9 : 6 , 2)7 0 / , 2) 0 ' %, 2) # < # <...
  • Page 4 " & " & ) # # * " & & " & # # & & & & & " " " & & , 1 1 & & # 3 " # & # 7 & % & # &...
  • Page 5 > # ' & " & & $ . =&= =#& " =#& $ / 1 $ 1 1 + / 1 + 1 1 & < $ 1 1...
  • Page 6 8) + . + * + * 8 ) ) " " & " & & ) # & 5 " " " & & 4 $ / " " & " > " & & & - 7 % &...
  • Page 7 NOTE! This appliance must never be used with the door open or removed. Before gaining access to the burner tray, first make sure that the stove is switched off and is cold. Now the cast iron door can be opened, this is secured in place by one fixing bolt.

  • Page 8: Important Note

    HANDLE HOT COALS OR LOGS WITH BARE HANDS AND NEVER PLACE HOT COALS OR LOGS ON OR NEAR COMBUSTIBLE SURFACES. NO RESPONSIBILITY FOR ANY INJURY HOWEVER CAUSED WHILST HANDLING HOT COALS, LOGS OR CERAMICS CAN BE ACCEPTED BY HUNTER STOVES LTD.
  • Page 9 ! "# Cut-out in Ceramic Place the ceramic matrix onto the traytop, making sure that the cut-outs in both of the front bottom corners of the ceramic line up with the corresponding matrix positioning brackets on the traytop. This is shown in diagram 7.

  • Page 10: You Should

    " HOULD 5 x Mini Ceramic Coals 4 x Small Ceramic Coals 2 x Medium Diamond Ceramic Coals The first coals to be placed are the two ‘Diamond’ shaped coals. These should be placed in diamond shaped cutouts as shown in diagram 9. Make sure that the coals do not block the flame port holes in the matrix.
  • Page 11 # " HOULD 1 x Y-Shaped Ceramic Log 2 x Small Branch Logs 1 x Short Straight Log 1 x Long Straight Log 1 x Twig The first log to be placed is the one of the small branch logs. This is placed around the left-hand front hole in the matrix as shown in diagram 12.
  • Page 12 The fourth log is the second of the small branch logs and should be positioned behind the furthermost right-hand flame port hole. The top of this should be rested against the back upright of the ceramic matrix, making sure that it is not directly above the rear flame port hole.
  • Page 13 " & " " # # " 7 # & $ 9 8 ) & " 8 , ' % The canopy is then secured in place by tightening the two fixing screws (one located either side of the canopy) with a flat-bladed screwdriver, shown in diagram 19.
  • Page 14 The system MUST NOT be adjusted, changed or put out of action by the installer. Replacement systems must be obtained from Hunter Stoves; no other pilot assembly must be substituted in its place.
  • Page 15 !& " & # " & & % < 0 & & " & " & & 6 " 5 E & 3 # & " " & & . < E & 3 & 7 & A 5 : 5 # &...
  • Page 16 &=# ! ( # " E 1 + / ( # " E 1 + 4 ( # " 55 0 E 1 + 6 E 1 + 9 E 1 , $ <1 4 E 1 1 $ & <1 4 E 1 1 + %<1 4 E 1 , A <1 9 E 1 .