Hunter Stoves Hawk User Instructions
Hide thumbs
Also See for Hawk:
- User instructions (5 pages) ,
- Installation and servicing instructions (16 pages) ,
- Installation and servicing instructions (18 pages)
Table of Contents
Advertisement
Quick Links
Hunter Hawk
Gas Stove
User
Instructions
Please leave this instruction booklet with the user after the installation is
complete. Leave the system ready for operation and instruct the user in the
correct use of the appliance and operation of its controls.
Please refer to the appliance data plate for the specific model type.
Revision C 29/08/2012
Advertisement
Table of Contents
Related Manuals for Hunter Stoves Hawk
Summary of Contents for Hunter Stoves Hawk
- Page 1 Hunter Hawk Gas Stove User Instructions Please leave this instruction booklet with the user after the installation is complete. Leave the system ready for operation and instruct the user in the correct use of the appliance and operation of its controls.
- Page 2 1. Read all instructions carefully before attempting to operate this appliance. 2. If you have any doubts about the suitability of your chimney for the appliance please consult your local Hunter Stoves stockist/dealer. The chimney must be given a precautionary sweep before connection to the appliance.
- Page 3 The ‘coals/logs’ may change colour after use, which is quite normal. • Replacement ceramic matrices and coals/logs must be sourced from your approved Hunter Stoves stockist. MPORTANT It will take approximately 15-20 minutes for the firebed to take on its proper appearance of glowing coals and yellow flames.
-
Page 4: Turning The Stove Off
Lighting the Pilot Flame With the gas control knob in the fully ‘off’ position, press the control knob in fully and turn anti-clockwise towards the ‘piezo ignition’ position on the control tap backplate. An audible click of the piezo igniter should be heard and a spark should be seen arcing between the pilot head and the pilot electrode. - Page 5 Important Note The stove is equipped with a sensor to monitor the function of the flue (TTB Switch). Should the flue lack sufficient draw to safely evacuate the products of combustion the fire will automatically shut off. If for any reason the fire does shut off, allow at least 3 minutes to elapse before attempting to relight as described in the “Operating The Appliance”...
- Page 6 The outside of the appliance is finished with a heat resistant paint and can be cleaned with a soft brush. Do not attempt to clean the appliance if it is hot. If required the finish can be renovated using either Hunter Stoves stove polish or Hunter Stoves stove paint.
Need help?
Do you have a question about the Hawk and is the answer not in the manual?
Questions and answers