Optional Equipment; Stove Legs; Pedestal - Lopi Answer Wood Stove Owner's Manual

Stove Leg Installation
Raise the stove 8" (use lumber). Attach each leg following the instructions below.
Attach each leg to the stove by
inserting a bolt and washer through the
hole or slot in the leg and into the
threaded hole on the stove.
These rubber-tipped bolts are for leveling the stove.
Make sure they contact the floor. Do not adjust
with weight on the legs, the rubber tips may tear.
Pedestal (Part # 99200106)
IIf using outside air with the pedestal, follow the directions below under "Using Outside Air with the
Pedestal" prior to installing the pedestal.
Use a 9/16" wrench to attach the two
pedestal bolts to the bottom of the stove.
9/16" Socket Wrench
The screen, insulation, cover plate,
and staples are used for outside
air.
Using Outside Air with the Pedestal
Before installing, check the section "Outside Air Requirements" on page 11 for installation concerns.
1. Determine the location of the outside air hole penetrating the floor (& hearth). The illustration
above details the size of pedestal and its location in relation to the stove. The hole may be cut
anywhere underneath the pedestal, as long as it is not within 2" of the outside perimeter of the
pedestal, is at least 16 square inches in area, and does not interfere with structural members of
the home. Place the rodent screen over the hole (above or below) and secure with staples.
Travis Industries

Optional Equipment

(Brass # 99200500, Cast Black # 99200800, Black Steel # 99200100)
23-5/8"
93508131
Stove

Pedestal

16-1/4"
9/16" Socket Wrench
The lag bolts
and washers
may be inserted
through the
holes in the
base of the
pedestal to
anchor the
pedestal to the
floor.
NOTE: when attached, the
stove front is flush with the
front of the pedestal.
4 020327
37