Rear Blower Installation - Lopi Answer Wood Stove Owner's Manual

Rear Blower Installation (Part number 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel.
Operating instructions are described in the section "Blower Operation" on page Error! Bookmark
not defined..
1 The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the thermodisk.
These wires pass
through the left side
convection channel.
Thermodisk
Assembly
3 Install the wire clip following the directions below.
Snap Disk
Wires
4 Attach the blower following the directions below.
Attach the quick-connects
a
leading from the snap disk to the
quick-connects from the blower
(orientation does not matter).
Travis Industries
Optional Equipment
Bend metal up or down
here to create a snug fit
Use a screwdriver to
pry out the knock-out.
Slide the wire clip
over the edge of the
strip of metal between
the two knock-outs.
Wire Clip
c
93508131
Insert the thermodisk
assembly 4" to 5" inside
the convection channel.
Feed the two snap disk wires into
the eye of the wire clip. Remove
all slack from the wire, making
sure not to dislodge the snap disk.
Pinch the eye of the wire clip to
secure the wires.
WARNING:
To prevent electrical shock, the
wires must be secured so they do
not contact the firebox above the
convection channel.
The blower attaches to the stove with the three
b
included screws. Use a 3/8" socket driver or wrench.
NOTE:
Prior to attaching the blower,
tuck all excess wire into the
area inside the blower.
Plug the power cord into a 110 V. outlet after installing the
blower.
39
Air
Control
Rod
3/8" Nutdriver
4 020327