Lopi Answer Wood Stove Owner's Manual page 42

42
3. Place the insert into the fireplace and connect the flue (if using a positive or direct
connection). Install the top panel and trim following the directions below.
a
Install the top panel so the two
tabs insert into the joggle clips on
the top panel.
Insulation Installation (required for face seal installations only)
1. With the insert drawn 6" from the fireplace, glue the insulation strip included with the
surround panel kit to the back of the panels using RTV silicon or stove gasket cement.
The insulation should be installed so it overlaps the fireplace opening to form a seal
between the panels and the fireplace face. Let the silicon or cement dry.
2. Push the insert into the fireplace, allowing the insulation to form a seal between the
panels and the fireplace. Use a screwdriver to tuck any exposed insulation behind the
panels.
Travis Industries
Optional Equipment
Top Trim
Top
Panel
93508131
Tighten the set screws from the
b
back side with a small standard
screwdriver
Top Trim
"L" Bracket
"L" Bracket
Right Side
Trim
Right
Side Construct the panel trim. Insert one leg of
each "L" bracket into the top and side trim
Trim
piece. Align the trim to form a precise corner,
then tighten the two set screws with a small
standard screwdriver. Slide the trim over the
Double-Back
panels. Attach a piece of included double-
Tape
back tape to the bottom of each side trim to
keep it from flaring at the bottom.
4 020327