Table of Contents
Advertisement
Power LED/Speaker
Pins 1-3 of JD1 are used for power
LED indication and pins 4-7 are for the
speaker. See the tables on the right
for pin definitions. Please note that the
speaker connector pins (4-7) are used
with an external speaker. If you wish to
use the onboard speaker, you should
close pins 6-7 with a jumper.
Standby Power Header
The +5V Standby Power header is lo-
cated at JSTBY1. See the table on the
right for pin definitions. (You must also
have a card with a Standby Power con-
nector and a cable to use this feature.)
Chapter 5: Advanced Serverboard Setup
PWR LED Connector
Pin Definitions
Pin Setting
Pin 1
JD1_PIN1
Pin 2
FP_PWR_LED
Pin 3
FP_PWR_LED
Speaker Connector
Pin Settings
Pin Setting
Pin 4
P5V
Pin 5
No Connection
Pin 6
R_SPKRIN_N
Pin 7
R_SPKRIN
Standby PWR
Pin Definitions
Pin#
1
2
3
5-19
Definition
Definition
Definition
+5V Standby
Ground
No Connection
Advertisement
Table of Contents
