Exit Programming; System Setting; Overview Of Parameters - Linkcom SlimDoorPhone 1 button Manual

ATTENTION !!! the deletion is non-reversible!!! Numbers must be programmed again.

5.6 Exit programming

Paramet
Value
er
9
After dialling 9 the unit will hang up.
press 9, the doorphone will stay in programming mode during 20 seconds.

5.7 System setting

Paramet
Value
er
6# s
The basic module is fitted with 4 buttons as standard, i.e. s = 1 is set up for basic module
with one button and s = 2 for module with 2 buttons. This setting is a factory one, no service
can change it and so it is recommended not to change this parameter.
Note: Connecting to the line the value of this parameter is checked and if not satisfactory for unknown
reasons, so it is set up to s = 4 (fitted with 4 buttons).
ATTENTION !!! This parameter can cause the unit to function incorrectly.
Paramet
Value
r
6 z
In default the unit produces acoustic signals. It can occasionally cause a problem of incorrect
detection of tones by PBX.
signalization. The values are:
z=0 – all signalling is switched off
z=1 – pick up and hang up tones are active only
z=2 – other tones active only
z=3 – all tones are active
It is possible to generate an audible signal (only in mode m=1) to alert visitors that the door
is unlocked so that they can enter. This is especially useful when using a DC power source,
as lock release may be silent.
z=8 – signalling is active
z=9 – signalling is unactive
Paramet
Value
er
t
6∗
Setes a delay for line pick-up (OFF HOOK) for new PBX types (particularly Siemens):
t=1 – standard operation
t=0 – delayed start

5.8 Overview of Parameters

Parameter Value
1 t nn...
Linkcom France
11 rue du Soleil Levant 92140 CLAMART
Description
E N D
If you hang up the phone during programming mode without
Description
Number of fitted buttons
of basic module
Description
Acoustic signalling
By changing parameter „z" you can switch off this acoustic
(except pick up and hang up)
default)
– (
Description
Delay of line connection
(Siemens PBX)
Description Default Exam.1 Exam.2
No. nn under
button t
Exam. Exam.
Default
1 2
Exam. Exam.
Default
1 2
Exam. Exam.
Default
1 2
3 and 3 and
3 and 9
9
Exam. Exam.
Default
1 2
1 1
- - -
Copyright © 2012 – Linkcom – Tous droits réservés
9
1
16