Disassembly Of Fore Bridge Component - Hisun HS500ATV-2 Maintenance Manual

Yanggakdo.
3.Check if the constant velocity joint is matched up well.
If not so or there is gear-cracked and abnormal
noise,remove the constant velocity joint and align
it .
4.Check if there exists any slip thread or flaw on the
open-groove nut .
5..Disassemble the front tank and check whether the gears
Is engaged properly.
6..In case the choke is jammed,it must be dredged with
a needle.If the problem is not solved,replaced it.
7.If there are defects on sensors ,it must be checked and
maintained by a professional.
8. Gears is fragile commondities in transmission system.

4.4.1.2 Disassembly of fore bridge component:

1.Detach the two front wheel parts.
2.Removed front Disk Brake Clip, cotter pin, cushion and
the front wheel hub. (Figure 4-2-20)
Figure 4-2-20
81