Firmware Update - Mobius ActionCam Instruction Manual

to show you which parameter combinations are allowed and which are not allowed. If you edit the
SYSCFG.TXT and enter invalid values the results are undefined and will lead to unexpected results.
Using Software to configure the camera
The Windows program mSetup.exe will automatically configure the camera with the parameters you
require. Detailed instructions can be found in the program by clicking the "Help" button. The program
is also used to synchronize the camera's internal clock with the computer's date and time.
►An official configuration tool which will work with many Android devices can be found in Google's
Play Store. Search for "therau2000" to list programs by this author.

Firmware Update

Normally, there is no need to update the firmware. You should only update the firmware if you are
having problems with the current firmware or the new firmware provides functionality you require that
are not available in your current version.
The latest firmware version can be downloaded and installed directly from the setup program or
installed manually by downloading the firmware file from
http://www.rcgroups.com/forums/showpost.php?p=25170908&postcount=3.
Updating the firmware is an easy and safe process, but you should take note that it is not possible to
update the firmware using SD cards with a capacity greater than 32GB unless they are formatted
to FAT32. The firmware update routine is a low-level routine called before the exFAT file system is
loaded. The low-level routine only supports the FAT32 file system.
Automatic Firmware Update
Use mSetup (Tools) to automatically update the firmware. This is by far the easiest method.
Manual Firmware Update
DO NOT PRESS ANY BUTTONS during the firmware update process.
There are two methods with which you can update the firmware.
Method 1 without pressing any buttons:
• Turn off the camera.
• Connect the camera to the computer and wait until the card is recognized as a Removable Drive.
• Copy the new firmware file into the camera's flash card root folder. All firmware files are
named FWTLCAM.BIN. The name must not be changed.
• Disconnect the camera from the computer and wait until it turns off.
• Wait until all the LEDs are turned off.
• Connect the camera to the PC. The blue LED will turn on for about 13 seconds and then begin
to flash. WAIT.
• After another 7 seconds the blue LED will turn off. WAIT.
• After a second or two the yellow LED will turn on.
• The firmware file will be automatically deleted.
• The camera will automatically be connected as a removable device.
• After about 4 seconds the process is complete and the yellow LED will turn off.
• The camera is now ready for use as a USB drive.
Method 2 by pressing the power button :
• Turn off the camera.
WAIT