Turn Off Camera; Switching Between Modes; Playback Mode - Mobius ActionCam Instruction Manual

camera will automatically begin recording in Mode 1 as soon as the power button is
pressed or external power is connected. If the recording LED has been disabled, the
yellow LED will blink 3 times and then turn off, indicating that recording has started.
Otherwise the yellow LED will slowly flash at 2 second intervals indicating that the camera is
recording.
• If the camera has been configured with "Auto Record" set to OFF (default setting), the
camera will switch to Video Mode 1 (yellow LED) and remain in standby mode until a
button is pressed or Auto-Power-Off times out.

Turn off Camera

Press and hold the Power Button for at least half a second and then release it (some firmware versions
require you to press the button for 2 seconds). The red LED will blink 3 times and the camera will turn
off.

Switching between modes

The camera can be switched between the different modes by pressing the Mode button. Each button
click advances the camera to the next mode. Video Mode1 - Video Mode2 - Photo Mode - Playback
Mode (only if A/V cable is attached) - Video Mode1 etc.
Recording Video Mode 1 or 2 (yellow or blue LED)
Start video recording and write-protecting important clips.
• Briefly press the shutter button.
• ► If the recording LED has been disabled, the yellow or blue LED will blink 3 times and
then turn off, indicating that recording has started.
• ► If the recording LED has been enabled, the yellow or blue LED will slowly flash at 2
second intervals indicating that the camera is recording.
• The current clip can be write-protected by pressing the Mode button while recording.
Depending on the length of the recording, the previous or next clip may also be marked as
write-protected (read-only).
Stop video recording.
• Briefly press the shutter button. The camera will return to the standby mode from which the
video was started.
Taking a Photo (red LED)
• Briefly press the shutter button. The red LED will flash indicating that a picture was taken.

Playback Mode

• Ensure you have an A/V cable connected between the camera and an external monitor and a
card is inserted.
• Turn on the camera if it is not already turned on.
• Press the Mode button until the red LED turns on (Photo Mode).
• Now press the Mode button once more. The red LED will remain on, but the camera will be in
playback mode and the first frame of the first clip found on the card will show on the external