Table of Contents
Advertisement
View Photos (Top-right icon on OSD menu).
► When the View Photos icon has the focus, press the Shutter button to enter the View
Photos screen.
A list of all the photos on the SD card will be shown.
► Press the Power button to move the focus to the next file on the list.
● Pressing the Power button on the last item in the list will return focus to the first
item
► Press the Shutter button to select the photo to be viewed in full-screen mode.
Firmware Update
New firmware versions usually correct issues found in previous versions but often provide
new functionality which was not previously available.
Use mSetup (click the 'Tools' button) to automatically update the firmware. This is by far
the easiest method.
Manual Firmware Update
DO NOT PRESS ANY BUTTONS during the firmware update process.
There are two similar methods with which you can update the firmware. Always use one
of these methods to update the FW.
Method 1 (recommended method):
•
Turn off the camera.
•
Connect the camera to the computer and wait until the card is recognized as a
Removable Drive.
•
Copy the new firmware file (MAXI4K.BRN) into the camera's flash card root folder.
•
Disconnect the camera from the computer and wait until it turns off.
•
Wait until all the LEDs are turned off.
•
Connect the camera to the PC. The green LED, indicating the battery is charging,
may turn on. WAIT.
•
The LEDs will blink indicating the firmware is being updated.
•
The firmware will be updated when the LEDs stop flashing. After a few seconds the
camera will beep once and will be recognized as a Removable Drive.
•
The firmware file will have been automatically deleted.
•
The date and time and all parameters will be reset to their default values.
Method 2:
•
Turn off the camera and remove the card.
•
Insert the card into an external card reader and connect the card reader to your
computer.
•
Copy the new firmware file (MAXI4K.BRN) into the card's root folder.
•
Safely disconnect the card reader from the computer and remove the card.
•
Insert the card into the camera. DO NOT turn the camera on or press any buttons.
•
Connect the camera to external USB power or connect the camera to the PC. The
green LED, indicating the battery is charging, may turn on. WAIT.
•
The LEDs will blink rapidly indicating the firmware is being updated.
•
The firmware will be updated when the LEDs stop flashing. The camera will then
automatically turn on with a beep.
•
The firmware file will have been automatically deleted.
•
The date and time and all parameters will be reset to their default values.
WAIT
WAIT
Advertisement
Table of Contents
