Mobius ActionCam Instruction Manual page 14

whatsoever.
When the card is pushed 1 mm inside the body the card should latch with a distinctive click.
Never force the card, and never push the card more than max. 1 mm into the camera body.
Q. When the camera is turned on, the blue LED turns on for a second and then the yellow LED turns on
as normal. However, the Mode and Shutter buttons don't react and I can't take any video or pictures.
The camera is also not recognized by my PC as a removable drive. When connected to the PC the green
LED may be on or off.
A. The lens module ribbon cable is not connected properly or the lens module is damaged.
Q. When recording video, the Yellow LED blinks once after which there is a 1 sec. delay and then the
blue LED blinks once. After another 4 sec. the sequence is repeated. No video is recorded.
A. The battery is not supplying a steady voltage and needs to be replaced immediately.
Q. When the camera is turned on, the blue LED turns on. It may turn off after a second or two. The
Mode and Shutter buttons don't react and I can't take any video or pictures. The camera is also not
recognized by my PC as a removable drive. When connected to the PC the green LED may be on or
off. The red LED may also blink 3 times while the camera turns off.
A. The lens module ribbon cable is not connected properly or the lens module is damaged.
Q. The camera does not react. The green LED may be on or off.
A. The firmware may have entered a continuous loop, or the battery may be discharged.
• Make sure the battery is fully charged.
• Use a paper clip or similar object to press the Reset button. This should force the camera to be
turned off.
• Wait 10 seconds.
• Turn on the camera.
• As a last resort, disconnect the battery and reconnect again after waiting 30 seconds.
Q. The camera functions normally but only records very short (5 sec.) clips and may turn off.
A. This can be caused by the following:
• The battery may not be charged. Charge the battery for about 2.5 hours until the green LED
turns off.
• The battery is too cold to provide the power needed to record video. Keep the battery warm
before using the camera in cold temperatures (around freezing and below).
• Check the integrity of your card by using the program h2testw to make sure your card is
genuine and not a fake card that has been up-rated.
• The card used is not compatible with the camera. Use class 4 cards. Kingston cards are
recommended.
• Problematic 64GB cards (or larger) may work better if formatted with FAT32 if used with
firmware v2.03 and below.
Q. The camera functions normally but the video is much too dark or too light or even completely black
or white. The first video scenes may be exposed correctly and the symptoms only appear after a certain
amount of time.
A. Check the following: