Webcam Mode - Mobius ActionCam Instruction Manual

monitor.
• ► If no clips are found on the card the display will show "Empty".
• Press the Shutter button to play or pause the clip.
• Press the Mode button to advance to the next clip.
• Press the Power button to exit Playback Mode and turn off the camera.
• ► It is not possible to exit Playback Mode except by turning off the camera.
Removable Disk Mode
• Make sure a memory card is inserted and the camera is turned off.
• Connect the camera to the PC using a standard USB cable. The green LED may turn on
indicating that the battery is charging.
• The blue LED will turn on for about a second but will then be replaced by the yellow LED.
After a short while the yellow LED may also turn off.
• The camera is now in Disk Mode and a new removable drive should be available on your
computer. This may take up to 30 seconds.
• ► You cannot record video or photos if the camera is connected to the PC in Removable Disk
Mode.
• ► It is not possible to enter Removable Disk Mode when using a Video-Out cable (pins #4 and
#5 shorted to ground).

Webcam Mode

There are two ways in which you can enter webcam mode.
Method 1:
• Connect the camera as a removable drive (see above).
• Press the Shutter button to enter webcam mode.
• ► If this is the first time you have connected the camera in WebCam mode, Windows will
automatically install the required drivers.
• ► Disconnect the camera or press the Power button to exit webcam mode.
Method 2:
• Remove the flash memory card.
• Connect the camera to the PC using a standard USB cable.
• The yellow LED will blink at 2 second intervals indicating there is no card inserted. This is
normal.
• ► If this is the first time you have connected the camera in WebCam mode, Windows will
automatically install the required drivers.
• The camera is now in Webcam mode.
• Start your favorite WebCam software, such as AMCap. If your screen is black, the software is
not configured correctly. Make sure the program shows the "USB PC camera" as the "device"
selected for video capture. If this option does not show in the "device" option list, restart the
webcam program and check again.
• Disconnect the camera or press the Power button to exit webcam mode.
►Note: Windows XP has an integrated WebCam viewer. Your Mobius should be visible in Explorer
(My Computer) as a "USB Video Device". This functionality does not exist in Windows 7.