Mobius ActionCam Instruction Manual

Instruction Manual for the Mobius ActionCam
Description
The above picture shows the arrangement of the user operating features.
The two heat sinks can become very hot during operation. This is normal, but all the same you should
never leave the camera turned on where the surrounding temperature exceeds ~47°C (118°F) - for
example in a car parked in the baking sun. If you wish to use the camera in very hot conditions you
should ensure the heat sinks are adequately cooled, for example by directing cool air onto the metal
plates or using a ventilator to dissipate the heat away from the metal plates. High temperatures will also
damage the internal LiPo battery. If you use your camera in very hot conditions with external power,
for example as a dashcam, you should consider replacing the battery with a Super Capacitor pair. These
can be purchased from most suppliers who sell the Mobius. A Super Capacitor pair enables the camera
to correctly save the last recording when external power is removed. A fully charged Supercap has
enough energy to keep the RTC (Real Time Clock) running for several days (about 7-10) without
external power connected. It only takes a few minutes to fully charge the Supercap.
►This manual does not cover replacing the internal battery or lens. If you need to do this, please refer
to the very detailed instructions found at http://www.rcgroups.com/forums/showpost.php?
p=25170910&postcount=4.
►This manual assumes the camera is loaded with the latest firmware available at the time of
writing. Functionality may vary with earlier or later firmware versions.
Cards
Generally speaking you may use any micro SD, micro SDHC or Micro SDXC card with a capacity of
up to 128GB with this camera. Larger cards are most likely also supported but not yet available. To
avoid card compatibility problems, always use quality cards with a speed rating of Class 4. There are
known problems with a few cards that have a higher class rating, for example some, but not all,
Sandisk 32GB Ultra (class 10) will not work properly with earlier firmware versions. You should use
firmware v1.17 or above with these cards. For the best compatibility use cards with a class 4 rating if