Zoneflex 7055 Physical Installation - Ruckus Wireless ZoneFlex User Manual

ZoneFlex 7055 Physical Installation

This section describes the physical installation instructions for mounting the Zone-
Flex 7055 to an electrical outlet box.
CAUTION!
within the same building, including the PoE powered network connection as
described by Environment A of the 802.3af standard.
CAUTION!
power and LAN connectivity running to the outlet box where the AP will be installed.
1 Prepare the electrical outlet box.
2 The ZoneFlex 7055 can be mounted to a variety of commonly used electrical
outlet box formats, including US style outlet boxes conforming to NEMA-WD6,
and EU style outlet boxes conforming to BS 4662.
NOTE The ZoneFlex 7055 comes with a bracket for a single 1-gang electrical
outlet box. For adjacent outlet boxes, use the optional Ruckus Wireless ZF7055
adjacent wall bracket kit (part number 902-0111-000).
• Remove the outlet box cover from the outlet box, retaining the original box
cover screws.
• Align the mounting bracket with the outlet box so that the screw holes line
up (the bracket provides multiple holes for different outlet box designs), and
• pull the Ethernet cable through the center of the mounting bracket.
• Affix the mounting bracket to the outlet box using the original outlet box cover
screws. If the original outlet box screw heads extend over 2mm from the
bracket, then use the enclosed low profile mounting screws instead.
• Run the required cables through the electrical outlet box allowing sufficient
slack for the cables to reach the not yet installed ZoneFlex 7055.
3 Connect the cables.
• Connect an Ethernet cable providing PoE power and network connectivity
to the PoE In LAN / Uplink port using either a standard RJ45 connector or
the 110 punch-down block (refer to
page
• If PoE power is not available, the AP can be powered using an optional DC
power adapter (Ruckus part #902-0170-XX10, sold separately)
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C
The AP and all interconnected equipment must be installed indoors
Ensure that you use a Cat5e or better Ethernet cable to supply PoE
102).
Installing the Access Point
ZoneFlex 7055 Physical Installation
"Using the 110 Punch down Block" on
99