Ruckus Wireless ZoneFlex User Manual page 92

NOTE Instructions on how to verify that the Access Point and FlexMaster can
communicate with each other are provided in
Management Only)" on page
5. Disconnect the Access Point from the Administrative
Computer
1 Disconnect the Access Point from the power source.
2 Verify that the power LED on the Access Point is off.
3 Disconnect the Ethernet cable from the administrative computer's Ethernet port.
6. Restore the Administrative Computer's Network Settings
(Optional)
1 On your Admin computer, open the Network Connections (or Network and
Dial-up Connections) control panel according to how the Start menu is set up:
• On Windows 7, click Start > Control Panel > Network and Internet >
Network and Sharing Center > Change Adapter Settings.
• On Windows XP, click Start > Control Panel > Network Connections.
2 When the Network Connections window appears, right-click the icon for Local
Area Connection, and then click Properties.
3 When the Local Area Connection Properties dialog box appears, select
Internet Protocol (TCP/IP) (TCP/IPv4 in Windows 7) from the list, and then
click Properties. The TCP/IP Properties dialog box appears.
4 Restore the computer's network settings by typing the original IP address
settings in the TCP/IP Properties dialog box.
5 On the TCP/IP Properties dialog box, click OK to close it.
6 Click OK again to close the Local Area Connection Properties dialog box.
You are now ready to connect the Access Point to your network.
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C
"Check the TR069 Status (FlexMaster
95.
Installing the Access Point
Step 1: Preconfigure the Access Point
92