Installation; Applications - Sirius Range Hoods SU900 Installation Instructions Manual

Applications

The SU900 - SUT900 – SUE900 can
either be installed inside a wall cabinet
(provided the inside depth is greater than
11") or used in a custom designed woo-
den hood. Where installed directly into a
wall cabinet, there are two options:
Directly into the cabinet without any
form of hood. Directly into the cabinet
together with Sch31A where the Sch31A
acts as a liner hood and is attached to ei-
ther the underside of the cabinet or into
the sides of the cabinets alongside.
The SU901 can either be installed inside
a wall cabinet or used in a custom de-
signed wooden hood.
directly into a wall cabinet, there are two
options:
Directly into the cabinet or directly into
the cabinet together with the adjustable
Pro liners where the adjustable Pro li-
ners act as a cabinet protection against
the heat. The depth of the adjustable pro
liners can vary from 23.5" to 25.9" )
The SU902 and SU903 can either be in-
stalled inside a wall cabinet or used in a
custom designed wooden hood.
Depending on which model is used, pre-
pare a cut-out in the underside of the
wooden hood to allow the powerpack to
fit up into the hood using the following
dimensions:
SU900 - SUT900 – SUE900 20"
10" X 19"
3/8 19/32
SU900 - SUT900 – SUE900 27"
10" X 26"
3/8 11/16
SU901
6
I NST ALL A TION
Where installed
32" X 16"
13/32 3/16
SU902
SU903 27"
9/16
SU903 35"
7/16
SU908
If Sch31A or a Pro Liner are being used,
they can be held up under the cabinet
and used as a template.
If Sch31A or a Pro Liner are to be used
for under cabinet application, they
should be installed now.
Installing a SCH31A with SU900 -
SUT900 – SUE900. Hold the Sch31A un-
der the cabinet and Screw it to the 4 hole
locations. Make sure it lines up with the
cut out in your cabinet. The power pack
has pressure springs (to be adjusted) on
the front and back that will "hook" onto
the top surface of the underside of the
hood when it is pushed up into the hole
that has been cut out (refer to figure 3).
Installing SU900 - SUT900 – SUE900
without a SCH31A. The power pack has
pressure springs (to be adjusted) on the
front and back that will "hook" onto the
top surface of the underside of the hood
when it is pushed up into the hole that
has been cut out (refer to figure 3).
fig. 3
10" X 26"
½
25/64
9" X 25"
15/16 9/16
9" X 33"
15/16 7/16
12" X 26"
5/8 2/2