Connecting Electricity And Ducting - Sirius Range Hoods SU900 Installation Instructions Manual

The power pack has pressure springs (to
be adjusted) on the front and back that
will "hook" onto the top surface of the
underside of the hood when it is pushed
up into the hole that has been cut out
(refer to figure 3).
Installing SU902. The power pack has
pressure springs (to be adjusted) on the
front and back that will "hook" onto the
top surface of the underside of the hood
when it is pushed up into the hole that
has been cut out (refer to figure 3).
Installing SU903. The power pack has
pressure springs (to be adjusted) on the
front and back that will "hook" onto the
top surface of the underside of the hood
when it is pushed up into the hole that
has been cut out (refer to figure 7-8).
fig. 7-8
8
Insert and Fix the 4 clamping levers as
described in the pictures 9.
fig. 9
Screw carefully in order to keep the pro-
duct straight.
INSTALLING SU908
There are four holes on the inside of the
SU908 to fix the unit intothe edge of the
base of the wooden hood (refer to figure 4).

Connecting Electricity and Ducting.

Please refer to the Electrical Supply sec-
tion on page 2 for the required location
of the electrical supply.
CAUTION: Make sure the power is tur-
ned off at source. Make electrical con-
nections (refer to Figure 10). Ensure that
the plastic flaps at the exhaust outlet for
the fan move freely and have not become
jammed or stuck.
fig. 10