Error Display - Canon PIXMA iP6210D Service Manual

3. ERROR DISPLAY

Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (Alarm LED Blinking in Orange)
LED display
There is no paper. 2 times
The paper is jammed. 3 times
Ink has run out.
Replace the ink
cartridge and close the
cover.
U041
The following ink 5 times
cartridge cannot be
recognized.
U051 / U059
Some ink cartridges 7 times
are not installed in
place.
U075 / U076
The following ink 15 times
cartridge cannot be
recognized.
U052
The following ink 4 times
cartridge cannot be
recognized.
U053
The waste ink
absorber is almost full.
Incompatible device
detected.
The following ink may
have run out.
U161
An ink cartridge that
was once empty is
installed.
U162
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Alarm
LED
Error
blinking
(Error code)
(Service
mode)
No paper
(ASF)[1000]
Paper jam[1300]
- No ink[1600]
The ink cartridges
are not
installed[1401],
or a non-supported
ink cartridge is
installed[1485].
Ink cartridge's
position is wrong.
[1487 / 1486]
Ink cartridge is not
installed.[1682]
Ink cartridge is not
installed properly.
- Waste ink absorber
full[1700],
or platen waste ink
absorber full[1710].
- The connected
digital camera /
video camera is not
supported for
Camera Direct
Printing.
- Ink remaining is
unknown.
[1685/1686]
Corrective action
Set paper in ASF, and press
the OK button.
Remove the jammed paper,
and press the OK button.
Replace the ink cartridge(s),
or press the OK button.
Check if supported ink tank(s)
is installed, and re-install
them properly, and then close
the front cover.
Install the ink cartridge(s) in
the correct position.
Re-install the ink cartridge(s)
properly and close the front
cover.
Or, turn off/on the printer
with the ink cartridges
installed.
Re-install the ink cartridge(s)
properly and close the front
cover.
Pressing the OK button will
clean the error, and enable to
print.
<Replace Ink absorber kit
(QY5-0148-000)>
<Replace Platen waste ink
absorber QC1-6014-000)>
Disconnect the cable from a
the digital camera/video
camera, and press the Reset
button, and then re-connect
the cable.
Install an new ink cartridge, or
press the OK button.
* When an cartridge that was
once used (excluding the
cartridge used just before) is
installed, this error occurs.
(See 8-2. Major Functions (4)
Remaining ink level detection
function.)
(8/25)
Remarks
When selecting to
press the OK
button, ink may run
out during printing.
Waste ink absorber
full warning
(service call error)
may appear.
When the error is
resolved by
pressing the OK
button, the function
for detecting the
remaining ink level
will be released.