List Of Error Display / Indication; Operator Call Errors (By Led Blinking In Orange) - Canon i960 Service Manual

2. LIST OF ERROR DISPLAY / INDICATION

Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected to
the printer.

2.1 Operator Call Errors (by LED Blinking in Orange)

LED
blinking
in orange
2 times No paper. (ASF) [1000]
No CD-R tray. [1001]
No paper in the photo paper tray.
[1004]
No paper in the paper feed
cassette. [1003]
3 times Paper jam. [1300]
Paper jam in the auto duplex
printing unit. [1304]
Paper jam in the paper feed
cassette. [1303]
4 times No ink.
[1601/1634/1635/1611/1612/1613]
5 times The print head is not installed
[1401], or it is not properly
installed (EEPROM data of the
print head is faulty) [1403/1405].
*1
6 times No CD-R tray feeder (during
CD-R printing). [1850/1855]
Presence of the CD-R tray feeder
(during paper printing).
[1851/1856]
*1
7 times No CD-R or DVD-R. [1002]
8 times Warning: The waste ink absorber
becomes almost full (approx. 95%
of the maximum capacity).
9 times The connected digital camera or
digital video camera does not
support Camera Direct Printing.
[2001]
Error
Set the paper in the ASF, and press
the Resume/Cancel button.
*1
Set the CD-R tray, and press the
Resume/Cancel button.
Set the paper in the photo paper
tray, and press the Resume/Cancel
button.
Set the paper in the paper feed
*2
cassette, and press the
Resume/Cancel button.
Remove the jammed paper, and
press the Resume/Cancel button.
*3
*2
Replace the empty ink tank(s), or
press the Resume/Cancel button.
Install the print head properly, and
close the front cover.
Or, with the print head installed,
turn the printer off and on.
Set the CD-R tray and tray feeder
properly, and press the
Resume/Cancel button.
Remove the CD-R tray feeder, and
press the Resume/Cancel button.
After setting a CD-R or DVD-R in
the tray, set the tray in the tray
feeder, and press the
Resume/Cancel button.
Pressing the Resume/Cancel button
will exit the error, and enable
printing.
In repair servicing, replace the
bottom case unit (QM2-0586), or
5-item set of the ink absorbers
(QC1-2232/2233/2234/2235/2236).
After removing the cable between
the camera and the printer, press
the Resume/Cancel button, and
re-connect the cable.
1 - 4
Solution
Pressing the
Resume/Cancel
button will exit the
error without ink
tank replacement,
however, ink may
run out during
printing.
The service call
error, indicating the
waste ink absorber is
full, is likely to occur
soon.
When connected to a
Direct Print
supported camera,
the green LED blinks
2 times.
Remarks