Canon PIXMA iP6220D Series Easy Setup Instructions

1 2
Unpack the Printer
Carefully remove all items from the box.
1
2
PIXMA iP6220D Photo Printer
Power Cord
3
4
Color FINE Cartridge
(CL-51)
Photo FINE Cartridge
(CL-52)
5
Documentation and
6
Software Kit
Prepare the Printer
Remove the shipping tape from the front and back of the
printer.
Open (a) the card slot cover first and (b) the front cover next,
Pull down and remove the protective material on the right
side.
(a) Card slot cover
(b) Front cover
Protective material
Close the front cover first and the card slot cover next.
Plug the power cord into the back of the printer and connect
the other end to a power outlet.
Press the POWER button. The printer will initialize. Wait until
the POWER lamp remains fully lit.
Power cord
NOTE: Do not connect the USB cable at this stage.
When the screen appears on the LCD, confirm a language
and then press the OK button.
NOTE: If you leave the printer more than five minutes without
using any button on the operation panel, the LCD goes
into sleep mode automatically. Press the OK button to
turn on the LCD again.
Open the card slot cover first and the front cover next.
The FINE Cartridge holder automatically moves to the left.
Write down the serial number. You will need this to register
the product.
FINE Cartridge
holder
Serial number

Start Here

Easy Setup Instructions
3
Install the FINE Cartridges
1 Take out the Color FINE Cartridge (CL-51) from its box and remove the protective
tape gently.
Print head nozzles
NOTE:
·Do not touch the electrical contacts or print head nozzles on a FINE Cartridge. The
printer may not print out properly if you touch it.
·Do not reattach the protective tape once you have removed it.
·Handle the removed protective tape carefully to avoid getting your hands dirty or
staining surrounding work area.
2 Insert the Color FINE Cartridge slightly slanted into the left slot (C).
3 Push up the Color FINE Cartridge until it clicks into place.
IMPORTANT: For correct printer operation, make sure the FINE Cartridge is secure in
slots.
Repeat the procedure for the Photo FINE Cartridge (CL-52), inserting it into the
4
right slot (P).
5 Close the front cover first and the card slot cover next.
IMPORTANT: Wait until the preparatory operation is complete; this takes about one
to two minutes.
The message requesting head alignment is displayed on the LCD.
Go to the next step.
4
Align the Print Head (FINE Cartridge)
1 Open the paper support and pull out the paper output tray.
Electrical contacts
To the FINE Cartridge holder
Protective tape
Pinch the paper guide and slide it to the left. Load a few
2
sheets of blank paper into the auto sheet feeder, then slide
the paper guide toward the left edge of the paper.
Paper guide
Paper thickness lever
NOTE: Ensure that the paper thickness lever is set to the left
position.
3 Ensure that the message requesting head alignment is dis-
played on the LCD, select Yes using the
then press the OK button.
The pattern is printed. And the print head is aligned
automatically.
IMPORTANT: It takes about four minutes to finish printing.
When automatic print head alignment can not be execut-
ed correctly, the message "Auto Head Align has failed.
Press [OK] and repeat operation. <See manual>" is dis-
played on the LCD. refer to "An Error Message is
Displayed on the LCD" in the Direct Printing Guide.
Continue with Step 5
on side two.
Series
Photo Printer
Paper support
Paper output tray
Auto sheet feeder
Print side
buttons and