Table 3-1
DVI-I
VGA
SVGA
XGA
WXGA
SXGA
WSGA
UXGA
WUXGA
Note:
If you connect a camera to the DVI-I input, the system will manage it as PC content.
Showing Contents from your Computer
Once a call has been established, you can show the contents of your computer to the remote
terminal.
Before showing contents, proceed as follows:
Procedure
Step 1
In the Main Menu page select Make your call.
Step 2
Press
Note:
Step 3
To end the presentation, press the
RADVISION | User Guide for SCOPIA XT1000 Version 2.0
Resolution and Refresh Frequencies
Resolution
640 x 480
800 x 600
1024 x 768
1280 x 768
1280 x 1024
1440 x 900
1600 x 1200
1920 x 1200
•
Configure your computer to the resolution and refresh rates supported by the system. See
Setting the Computer Display page 20
•
Connect your computer to the DVI-I input of the Codec Unit. See the Quick Setup Guide for
installation instructions.
•
Check that the remote terminal supports Presentation mode. Otherwise, once the call has
been established, the system will send automatically the computer content instead of the live
camera video.
to start the presentation.
If you are not in a call, the presentation starts only on your computer. If you are in a call,
the system will automatically enter Presentation mode and send the live camera video
and your presentation to the remote terminal.
Refresh Frequency (Hz)
60, 72, 75, 85
56, 60, 72, 75, 85
60, 70, 72, 75, 85
60, 75
60, 67, 70, 72, 75, 76, 85
60
60
60
for detailed information.
key.
'Managing Calls' | 21