Transceiver Installation/Removal - ZyXEL Communications AX Series User Manual

The following table describes the items on the ports panel of PX5531-T0.
Table 22 Panel Ports and Buttons
LABEL
POWER
USB
LAN 1-4
Phone
WPS
RESET

2.3.9 Transceiver Installation/Removal

Transceiver Installation
Use the following steps to install an SFP transceiver.
Attach an ESD preventive wrist strap to your wrist and to a bare metal surface.
1
Align the transceiver in front of the slot opening.
2
Make sure the latch is in the lock position (latch styles vary), then insert the transceiver into the slot with
3
the exposed section of PCB board facing down.
Press the transceiver firmly until it clicks into place.
4
The Zyxel Device automatically detects the installed transceiver. Check the LEDs to verify that it is
5
functioning properly.
Remove the dust plugs from the transceiver and cables (dust plug styles vary).
6
Identify the signal transmission direction of the fiber cables and the transceiver. Insert the fiber cable into
7
the transceiver.
Figure 41 Latch in the Lock Position
Figure 42 Transceiver Installation Example
Chapter 2 Hardware
DESCRIPTION
Connect the power adapter and press the ON/OFF button to start the device.
The USB port is used for cellular WAN backup, file-sharing, and media server.
Connect computers or other Ethernet devices to Ethernet ports for Internet access.
C
onnect analog phone to the PHONE port with RJ11 cable for VoIP services.
Press the WPS button once within 3 seconds to quickly setup a secure WiFi connection between the
device and a WPS-compatible client.
Press the button for more than 5 seconds to return the Zyxel Device to the factory defaults.
AX/DX/EX/PX Series User's Guide
62